Menu system – Kenwood KDC-MP5032 User Manual
Page 26
26
|
English
Menu system
In Standby mode
Demonstration mode Setting
Sets the demonstration mode.
1
Select the Demonstration mode
Push the Control knob towards [FM] or [AM].
Select the "DEMO" display.
2
Set the Demonstration mode
Press the Control knob for at least 2 seconds.
Each time you press the knob at least 2 seconds,
the Demonstration mode alternates between the
settings shown in the table below.
Display
Setting
"DEMO ON"
The Demonstration mode function is ON.
"DEMO OFF"
Exit Demonstration mode (Normal mode).
3
Select Audio Preset mode
Push the Control knob towards [FM] or [AM].
Select the "A- PRESET" display.
4
Enter Audio Preset mode
Press the Control knob for at least 1 second.
5
Select the Audio Preset Recall
Push the Control knob towards [FM] or [AM].
Select the "RECALL" display.
6
Recall the Audio Preset
Press the Control knob for at least 2 seconds.
The "RECALL" display blinks 1 time.
7
Exit Menu mode
Press the [MENU] button.
• The User memory of
changed to the value which was recalled.
• The source tone memory item of
(page 10) is changed to the value which was recalled
by the selected source.
Other than Standby mode
Audio Preset Recall
Recalling the sound setup registered by
1
Select the source
Press the [SRC] button.
2
Enter Menu mode
Press the [MENU] button for at least 1 second.
"MENU" is displayed.
Other than Standby mode
Audio Preset Memory
Registering the value setup by Sound Control. The
memory cannot be erased by the Reset button.
1
Setup Sound Control
Refer to the following operations to setup the
Sound Control.
-
2
Enter Menu mode
Press the [MENU] button for at least 1 second.
"MENU" is displayed.
3
Select Audio Preset mode
Push the Control knob towards [FM] or [AM].
Select the "A- PRESET" display.
4
Enter Audio Preset mode
Press the Control knob for at least 1 second.
5
Select the Audio Preset Memory
Push the Control knob towards [FM] or [AM].
Select the "MEMORY" display.
6
Put the Audio Preset in the memory
Press the Control knob for at least 2 seconds.
The "MEMORY" display blinks 1 time.
7
Exit Menu mode
Press the [MENU] button.
• Register 1 pair of Audio Preset Memory. You cannot
register by the source.
• When you press the Reset, all the sources will be the
setting value which is registered.
• The following items cannot be registered.
Volume, Balance, Fader, Loudness, Volume offset, Dual
Zone System, Rear Volume