Connecting the fm and am antennas – Samsung HT-DS1870 User Manual

Page 10

CONNECTIONS

The cooling fan dissipates the heat generated inside the unit so that the unit can be operated
normally. The cooling fan is activated automatically to supply cool air to the unit.

Please observe the following cautions for your safety.

•

Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit could rise and may dam-
age it.

•

Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a newspaper or
cloth, heat may build up inside the unit and fire may result.)

Cooling Fan

Connecting the FM and AM Antennas

FM antenna connection

AM antenna connection

1. Connect the FM antenna supplied to the FM 75

Ω

COAXIAL terminal as a temporary measure.

2. Slowly move the antenna wire around until you find a location where reception is good, then

fasten it to a wall or other rigid surface.

• If reception is poor, connect an outdoor antenna.

Before attaching a 75

Ω

coaxial cable (with a standard type connector), disconnect the supplied FM antenna.

1. Connect the AM loop antenna supplied to the AM and terminals.

2. If reception is poor, connect an outdoor single vinyl-covered wire to the AM terminal.

(Keep the AM loop antenna connected).

Snap the tabs on the loop into the
slots of the base to assemble the
AM loop antenna.

FM Antenna (supplied)

AM Loop Antenna
(supplied)

If AM reception is poor, connect an outdoor

AM antenna(not supplied).