Kenwood KTC-H2A1 - Manual (Page 13)

Clock Setup
Here
2
Anywhere has an automatic clock that receives its
time signal as part of the SIRIUS satellite stream.
To set the clock, you need to tell Here
2
Anywhere what
time zone you live in and if your local area observes
Daylight Savings Time.
1. While in the Setup Mode, press the left or right arrow
buttons until the Auto Clock Setup screen appears
(top, right).
2. Press the up or down button once and the Time Zone
Setup screen appears (middle, right).
3. Press the up or down arrow buttons until your time
zone is highlighted, then press the SELECT button.
• The screen will change to the Daylight Savings screen (bottom, right).
3. If your local area observes Daylight Savings Time, press the SELECT button so an “X” appears in the box
on the display’s fourth line; if your local area does
not observe Daylight Savings Time, press the SELECT
button so that the box is empty.
Note: If you drive into another time zone (or into an
area with a different Daylight Savings Time status than
your local area) you will have to re-set the clock.
25 24
Here
2
Anywhere Instruction Manual (ver. 2)
Time Zone Setup Screen
Daylight Savings Screen
Press the DISPLAY button to cycle the display between the two modes.
Adjusting the display brightness
Hold the DISPLAY button down for over 1 second to
enter the Display Brightness mode (right):
1. Use the up & down arrow buttons to select the
desired brightness level (high/medium/low)
2. Press the SELECT button to save your selection
• Press the DISPLAY button to exit this mode
Setup Mode
The Setup Mode lets you access and set up the following features: SID (SIRIUS ID Number), Auto Clock
Setup, Alarm Clock Setup, Channel Skip/Lock, Lock Code Setup, Auto Shutoff Setup, Startup Mode, Output
Level, Text Flow Type, Audible Alert, and Antenna Signal.
To enter the Setup Mode, hold the POWER button on the front panel for at least 1 second. Use the left &
right arrow buttons to move to the setup feature you want, and press the SELECT button to select the
feature. To exit the Setup Mode and return to the previ-
ous operation mode, press the POWER button at any
time while the Setup Mode is active.
SID
When you first enter the Setup Mode, the unit’s unique
12-digit SIRIUS ID Number will be displayed (right):
Here
2
Anywhere Instruction Manual (ver. 2)
Display Brightness Screen
SIRIUS ID Screen
Auto Clock Setup Screen