Kenwood TK-7160 - Manual (Page 20)

14
DTMF CALLS
Note: To make DTMF calls, you must have an optional microphone with a DTMF keypad.
S
TORE
& S
END
1 Enter the desired digits on the microphone keypad.
• You can enter a maximum of 16 digits (0 ~ 9, A ~ D, , and #).
• The digits appear on the display as you enter them.
• If Keypad Auto-PTT is enabled by your dealer, this method of entering a string of
digits will not function. Refer to “M
ANUAL
D
IALING
”, below.
2 Press the PTT switch to transmit the entered digits.
M
ANUAL
D
IALING
1 Press and hold the PTT switch.
2 Enter the desired digits on the microphone keypad.
• You can enter the digits 0 ~ 9, A ~ D, , and #. (A ~ D may be disabled by your
dealer.)
• If Keypad Auto-PTT is enabled by your dealer, you do not need to press the PTT
switch while entering digits; the transceiver will transmit the DTMF tones
automatically as you enter the digits.
S
TORING
DTMF N
UMBERS
If Auto Dialing has been activated by your dealer, you can store DTMF numbers
(16 digits maximum) in each of the 9 Auto Dial memory locations (1 ~ 9).
1 Press the microphone # key.
• “ ” appears on the display.
2 Enter the desired digits on the microphone keypad.
• You can enter the digits 0 ~ 9, A ~ D, , and #.
• To enter “#”, press and hold the PTT switch while entering the # key.
• To cancel, press any key on the transceiver front panel.
3 Press the microphone # key, then enter a memory location number (1 ~ 9).