Kenwood TK-7160 - Manual (Page 19)

13
A
DD TO
S
CAN
/ D
ELETE FROM
S
CAN
Depending on how your transceiver has been set up, a key may have been
programmed with the Scan Del/Add function. This function allows you to scan
only those channels which you desire.
To add or remove a channel to/from the Scan list, select the desired channel
then press the Scan Del/Add key.
To temporarily remove a channel from the Scan list, during Scan, press the Scan
Del/Add key while Scan is paused on the undesired channel. After switching the
Scan function OFF, or switching the transceiver OFF and then ON again, the
Scan settings return to normal.
The icon appears on the display when the selected channel is added
to the Scan list. The icon disappears when the selected channel is
removed from the Scan list.
To add or remove a zone to/from the Scan list, select the desired zone then
press and hold the Scan Del/Add key for approximately 1 second.
To temporarily remove a zone from the Scan list, during Scan, press and hold the
Scan Del/Add key for approximately 1 second while Scan is paused on a
channel in the undesired zone. After switching the Scan function OFF, or
switching the transceiver OFF and then ON again, the Scan settings return to
normal.
The icon appears on the display when the selected zone is added to
the Scan list. The icon disappears when the selected zone is
removed from the Scan list.
R
EVERT
C
HANNEL
During Scan, pressing the PTT switch to transmit will cause the transceiver to
select the Revert channel. Your dealer programs the Revert channel for your
transceiver with one of the following six types:
• Selected: The last channel selected prior to Scan is the Revert channel.
• Selected + Talkback: While the transceiver is paused on a channel during
Scan, pressing the PTT switch will allow you to transmit (talk back) on the
current channel. Otherwise, the last channel selected prior to Scan is the
Revert channel.
• Priority: If your dealer has programmed a Priority channel, this channel is
the Revert channel.
• Priority + Talkback: While the transceiver is paused on a channel during
Scan, pressing the PTT switch will allow you to transmit (talk back) on the
current channel. Otherwise, the Priority channel is the Revert channel.
• Last Called: The last channel on which a call was received is the Revert
channel, even if Scan has already resumed.
• Last Used: The last channel on which you transmitted is the Revert channel.