Program the timer, Install covers and restart water heater – Kenmore IntelliSoft 350 Series 625.383560 User Manual
Page 17
17
Program The Timer
Capacity Plus
Capacity Plus
Ultracleansing
Ultracleansing
Adjustable Low Salt Indicator
Adjustable Low Salt Indicator
350 Series
Display
DOWN Button
Model 38356
Model 39356
UP Button
REGENERATION Button
SELECT Button
AM
PRESENT TIME
AM
PRESENT TIME
PROGRAM THE TIMER
1. When the transformer is plugged in, a model code and a
test number (example: J11) show in the face plate. This
will display for four (4) seconds. Then, 12:00 AM and
PRESENT TIME begin to flash.
NOTE: If “- - - -” shows in the display, press the UP or
DOWN button until either S 32, for Model 38356, or
S 33, for Model 39356, shows in the display Then,
press the SELECT button to set, and change to the
flashing PRESENT TIME display.
2. To check the model code, unplug the transformer at the
wall outlet and plug in again. If other than this code
shows, refer to the Troubleshooting Section.
SOUND “BEEPER”: A “beeper” sounds while pressing
buttons for timer setup. One beep signals a change in the
face plate display. Repeated beeps mean the timer will not
accept a change from the button you have pressed, telling
you to use another button. For example, while setting the
hardness the beeper sounds repeatedly when the display
reaches 1 using the DOWN button, or the highest hard-
ness setting using the UP button.
FIG. 25
FIG. 24
Install Covers and Restart Water Heater
FIG. 23
INSTALL COVERS
After installing your water softener, replace the covers.
Angle the covers so the main cover clips onto the back
first, then bring down in front and clip on the two (2) tabs
inside the rim of the salt hole and lower the salt cover
closed. See Fig. 23.
RESTART THE WATER HEATER
Turn on the gas (or electric) supply to the water heater
and light the pilot.
YOUR PLUMBING INSTALLATION AND ELECTRICAL
WORK ARE NOW COMPLETE.
Salt Hole
Cover
Cover
(Main)
Questions? Call The Kenmore Water Line 1-800-426-9345