Kenwood APCO P25 TK-5710 - Manual (Page 21)

16
S
CAN
P
ROGRAMMING
Using the key programmed as Scan Program, you are able to reprogram your
scan list.
1 Press the key programmed as Scan Program.
• The (KCH-14 ) or SCAN (KCH-15) icon appears on the display and blinks.
2 Press the GRP and keys or rotate the CH control to select the zone
and channel you will add to or remove from the Scan list.
• Press the PF 4 key (the forth key from the left, after the CH control) to toggle
between Zone Select and Channel Select.
3 Press the PF 2 key (the second key from the left, after the CH control) to add
or remove the selected zone or channel to/ from the scan list.
• The channel add indicator (KCH-14: / KCH-15: ) will
appear on the display when the selected channel is added to the scan sequence.
If the Priority channel has been set as Operator Selectable by your dealer, you
are able to reprogram the Priority mode as well.
1 Press the key programmed as Scan Program.
• The (KCH-14) or SCAN (KCH-15) icon appears on the display and blinks.
2 Press the GRP and keys or rotate the CH control to select the zone
and channel you will add to or remove from the Scan list.
• Press the PF 4 key (the forth key from the left, after the CH control) to toggle
between Zone Select and Channel Select.
3 Press the PF 3 key (the third key from the left, after the CH control).
4 Press the PF 4 key (the forth key from the left, after the CH control) to toggle
the selected channel between Priority mode and Normal mode.
• “P1”, “P2”, or “PP” appears on the sub-display when Priority mode is
selected.
5 Press the PF 3 key again to set the new channel setting.