Kodak SERIES I 4700 - Manual (Page 16)

16 Photo Printer 4700 Series
3. Place a stack of no more than 100 sheets of paper, shiny side up for photo
paper and sticker side up for sticker paper, (Kodak logo facedown for both) at
a slight angle in the tray.
4. Push the paper against the internal side bias springs and under the right corner
nail.
5. Lower the paper into the paper tray. Fit the left edge of the paper under the left
corner nail.
6. Hold the paper down below the paper tray sides and close the paper tray cover.
Discard the cardboard if you are loading photo paper. Discard the top sheet of
protective material if you are loading sticker paper.
7. Line up the paper tray grooves with the printer grooves. Slide the tray straight
back until it locks in place. The tray slides best on a flat, smooth surface.
Side Bias Springs
Right Corner Nail