Kodak SERIES I 4700 - Manual (Page 11)

Photo Printer 4700 Series 11
Connecting the Cable and the Power Cords
Standard power cords are provided. The printer also requires a 1284 parallel
cable which you may need to provide.
To connect the 1284 parallel cable:
1. With the printer power and the computer power off, plug the cable’s DB-25
pin connector into the DB-25 (parallel port) connector on the back of the host
computer. Tighten the screws on the connector to lock it into place.
2. Plug the cable’s Centronics-36 pin connector into the Centronics-36 connector
(top connector) on the back of the printer. Adjust the cable clips on the pin
connector to lock it into place.
To connect the power cord:
1. Turn the printer power off.
2. Locate the power cord for your geographic region. The following power cords
are included with your printer.
3. Plug the appropriate end of the power cord into the port on the printer.
4. Plug the power cord into the power outlet.
5. Set the power switch to On.
United States
Australia
Europe
Power Cord
Connector 1284 Parallel
Connector