Kenwood B64-3537-00/00 KDC-W5037Y - Manual (Page 31)

English | 31
Installation
Firewall or metal support
Screw (M4X8)
(commercially available)
Self-tapping screw
(commercially available)
Metal mounting strap
(commercially available)
Bend the tabs of the
mounting sleeve with a
screwdriver or similar utensil
and attach it in place.
⁄
• Make sure that the unit is installed securely in place. If the
unit is unstable, it may malfunction (for example, the sound
may skip).
Installation
Screwing the Faceplate on the Unit
If you want to fasten the faceplate to the main unit
so that it does not fall off.
1 Refer to the section
frame> and then remove the hard rubber frame.
2 Drop open the faceplate by pressing the Release
button.
3 Tighten the screw (ш2 Ч 5 mm) (Accessory 4) and
bracket (Accessory 5 ) in the hole shown on the
diagram.
Accessory 4
Accessory 5
4 Tighten the screw (ш2 Ч 5 mm) (Accessory 4) and
bracket (Accessory 6) in the hole shown on the
diagram.
Accessory 4
Accessory 6
¤
• Never insert the screws in any other screw hole than the
one specified. If you screw them in another hole, it will
contact and may cause damage to the mechanical parts
inside the unit.