Kyocera KM-P4850w - Manual (Page 26)

CHAPTER 3 GETTING READY FOR PRINTING
3-8
8 Grasp both paper roll insertion latches 3 and open the
paper roll insertion cover 4.
9 Insert the leading edge of the paper under the paper roll
insertion guide and advance the edge past the guide
approximately 1/2" [10 mm] as shown in the illustration.
NOTE
If the leading edge of the paper roll is folded or broken, cut a clean
edge using a cutter.
10 Grasp the paper roll insertion latches and close the paper roll
insertion cover securely.
3
3
4
1/2"
[10mm]
IMPORTANT
If the paper roll that has been set is slackened, grasp the flange and
wind the paper roll to remove the slack. If not, the paper may be fed
obliquely.
11 Insert the roll unit securely into the main body of the
machine.
12 Close the front cover.
13 To align the leading edge of the paper roll, use the N or M
key to select a paper tray and press the Roll Cut key. The
leading edge of the paper roll will be ejected from the paper
eject slot.
NOTE
• Paper is normally cut in lengths of 11" [279 mm]. If the temperature
in the machine is lower than 15 °C, however, vellum will be cut in
lengths of 31" [800 mm].
• When a paper roll has been replaced during printing, press the On
Line key to place the printer offline and then press the Roll Cut key.
To continue printing press the On Line key once more to place the
printer online.