KVH Industries KVH TracVision TracVision G6 - Manual (Page 20)

Using the ADCU Interface
54-0161-01 21
3.5 Installing a New Satellite Pair
TracVision G6 permits two satellite services (Satellites A and B) to
be installed simultaneously. There is also an option for NONE on
Satellite B, permitting single satellite operation. Refer to the
Quick Reference Guide on page 18 f
or instructions on reaching
this menu.
Install Satellite?
Enter Next Return
Install A
Yes Next Cancel
Install B
Yes Next Cancel
Installing sats
Please wait
and
installed
Selecting NEXT will cycle
the display through all
available satellites
Selecting NEXT will cycle
the display through all
satellites that can be paired
with the selection for
Satellite A. If no satellite is
available for a pair or you
wish a single satellite
configuration, select NONE.
Refer to Tables 1-1 and 1-2
for available satellite
pairs.
Latitude: ##N
- Enter +
Longitude: ###E
- Enter +
Latitude: ##N
Longitude: ####E
Enter your latitude. Use the -/+
keys to select each number and
choose between NORTH and
SOUTH. Selecting ENTER will
cycle the display through each
digit and the direction option and
then launch the LONGITUDE
screen.
Enter your longitude. Use the -/+
keys to select each number and
choose between EAST and
WEST. Selecting ENTER will cycle
the display through each digit and
the direction option and then
display the selected latitude and
longitude.
Restart antenna?
Yes No
Restart
Antenna
System
(Recommended)
Figure 3-5
Install Satellite Pair Process
If a GPS is providing latitude and
longitude to TracVision G6, this
data will automatically be used in
the satellite installation procedure.
In this event, the menus will skip
directly to “Restart Antenna.”