General features, Audio setup, Speaker setting – Kenwood DPX301 User Manual
Page 10
10
|
English
General features
Audio Setup
Setting the Sound system, such as Cross over
Network.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Setup the Audio item
Turn the [VOL] knob.
Adjustment Item
Display
Range
Front High Pass Filter "HPF"
Through/40/60/80/100/120/
150/180/220 Hz
Rear High Pass Filter
"HPR"
Through/40/60/80/100/120/
150/180/220 Hz
Low Pass Filter*
1,2
"LPF"
50/60/80/100/120/
Through Hz
Subwoofer Phase*
1,2,3
"PHAS"
Reverse (180°)/ Normal (0°)
Volume offset
"V-OFF"
–8 — ±0
Loudness
"LOUD"
OFF/ON
• Volume offset: Sets each source’s volume as a
difference from the basic volume.
• Loudness: Compensates for low and high tones
during low volume.
• *
1
You can control this item when
(page 22) is set to "SWPRE SW".
• *
2
You can control this item when Output> (page 12) is set to "SW ON". • * 3 You can control this item when Low pass filter is not set to Through. 5 Exit Audio Setup mode Press the [VOL] knob for at least 1 second. Speaker Setting Fine-tuning so that the System Q value is optimal 1 Enter Standby Press the [SRC] button. 2 Enter Speaker Setting mode Press the [VOL] knob. 3 Select the Speaker type Turn the [VOL] knob. Speaker type Display OFF "SP OFF" For 5 & 4 in. speaker "SP 5/4" For 6 & 6x9 in. speaker "SP 6*9/6" For the OEM speaker "SP OEM" 4 Exit Speaker Setting mode Press the [VOL] knob.
when setting the speaker type.
Select the "STANDBY" display.
Each time you turn the knob, the setting
alternates between the settings shown in the
table below.