Kyocera KM-C830 - Manual (Page 116)

Section 7 COPIER MANAGEMENT
7-21
& Custom erase size
1 Press the O cursor or the P cursor key to select the length
of the original to be used in the custom erase mode.
(The length can be set to any 5/16" increment between
3
11/16 " and 8 7/16 " [any 8 mm increment between 94 mm and
214 mm.])
Inch specifications
Metric specifications
2 Press the N cursor key to change to the width size setting.
3 Press the O cursor or the P cursor key to select the paper
width. (The length can be set to any 1/8" increment between
2
3/8 " and 11 5/8 " [any 4 mm increment between 60 mm and
296 mm.])
Inch specifications
Metric specifications
4 Press the Enter key.
* Insert tray
1 Use the M cursor or the N cursor key to select the drawer
that contains the paper which will be fed in the insert sheet
modes.
* The “1 paper” [“SOURCE 1”] drawer is not available in
duplex copiers.
Inch specifications
Metric specifications
2 Press the Enter key.
( Sort mode ON/OFF (Output form)
1 Use the M cursor or the N cursor key to select either
“z On” or “x Off”.
Inch specifications
Metric specifications
2 Press the Enter key.