Samsung SPH-A460 - Manual (Page 23)

Section 2
Getting to Know Your Sprint PCS Phone 23
G
e
tti
ng t
o
Know
Y
our Ph
one
2
Using the Battery
Battery Capacity
Your Sprint PCS Phone is equipped with a Lithium Ion (LiIon) battery. It
allows you to recharge your battery before it is fully drained. The battery
provides approximately
xx hours of continuous digital talk time
( xx hour in analog) or approximately xx hours of continuous digital
standby time ( xx hours in analog).
Approximately five minutes before the battery charge level gets too low to
operate the phone, the battery sensor will let you know by blinking an
empty battery icon (
), sounding an audible alert and displaying a
warning message. If you continue to operate the phone without
charging, the phone will turn off automatically (after a three to five
minute delay). If this happens, your call will end.
Note: Long backlight settings, searching for service, vibrate mode and
Browser use affect the battery’s talk and standby times.
Tip: Be sure to charge your phone’s battery and watch your indicator to
ensure your levels are okay.
Installing the Battery
Your Sprint PCS Phone comes with a LiIon battery. Follow these steps to
install it:
1. Place the battery on to the back of the phone, making sure that the
three plastic tabs line up with the corresponding slots on the phone.
2. Gently push the battery down and upward on the phone until it snaps
into place.