Kodak A-61195 - Manual (Page 13)

8 A-61195 July 2003
Making connections
Connect the power cord and SCSI signal cable as shown below. Several
power cords are supplied with the scanner. Use only the cord required for
your type of power. Dispose of the unneeded power cords properly.
Use only the power supply that was provided with the scanner.
CAUTION: The power supply must only be used indoors in a dry location.
IMPORTANT: Do not substitute another power supply model or another
manufacturer’s power supply.
1. Attach the power supply to the power input on the back of the scanner.
2. Attach the power cord for your power type to the power supply.
3. Plug the power cord into a power outlet.
NOTE: Make sure that the power outlet is located within 1.52 metres (5 feet)
of the scanner and is easily accessible.
4. Attach a SCSI cable to the SCSI port.
NOTE: There are two SCSI ports on the scanner. You can use either a DB25
(male) or a 50-pin Amphenol connector to connect to the scanner.
5. Attach the other end of the SCSI cable to your PC.
SCSI ports
SCSI cable connector
Power supply input
Power switch
Power supply