Kingston Technology EtheRx KNE8TX/WG - Manual (Page 14)

8 Rear Panel
Kingston Technology Company KNExTX/WG User’s Guide - Rev. A00
Rear Panel
Fig. 1-6 KNE4TX/WG Rear Panel
Fig. 1-7 KNE8TX/WG Rear Panel
4 or 8 UTP Ports
The UTP ports are numbered 1 through 4 or 1 through 8 for 100BASE-TX
connections. Since crossover function is implemented on all UTP MDI-X
ports, a straight-through UTP cable should be used. (Note: Port 4 and Port 8
support both cable types using the cascade switch. Refer to Appendix A & B
for details on RJ-45 pin assignments and cable guidelines.
DC Power Connector
The EtheRx hub gets its power from the auto-sensing power supply. Insert the
power jack into the DC power connector located to the far right. For safety
purposes, ONLY use the included power supply for proper operation. The
wrong type of power supply may cause damage to both the EtheRx hub and the
power supply. (NOTE: The power supply output voltage is 5VDC/2.0A.
Polarity on the power jack and DC power connector is negative (-) on the
outside and positive (+) on the inside.)
Fig. 1-8 DC Power Connector
5V 2A
1 2 3 4
8 1 2 3 4 5 6 7
5V 2A
5V 2A
Rear Panel View
DC Power Jack
DC Power Connector