Kodak KY0730485 User Manual
Page 4
Matchprint Professional Server for DocuColor 12 Printer/Copier – Quick Start
2002 Kodak Polychrome Graphics. All Rights Reserved.
4
Product Safety and Compliance
Warning!
Do not modify or use any AC power cord other than the one included with
shipping.
In some cases, the supplied power cord may not be compatible with the AC
wall outlet in your region. If this is true, you must obtain a suitable power cord
that meets the following criteria:
The cord must be rated for use at the AC voltage available, with a current
rating that is at least 125% of the current rating of the product.
The AC plug end must be terminated in a grounding-type male plug designed
for use in your region. The plug ends must be labeled or marked to indicate
they have been certified by an agency acceptable in your region.
The connector at the product end must be an IEC 320, sheet C13, female
connector (or the equivalent EN 60 320 connector.)
The cord must be less than 14.8 feet (4.5 meters) long and, for use in Europe,
be created with
Warning!
1. The user must never remove chassis covers. Some system circuitry retains
voltage even when the system is turned off. Only qualified service technicians
should remove chassis covers.
2. There are no user-serviceable components in the KPG server. Refer all
system repair to a qualified service technician.
Warning!
The power supply voltage standby circuit is active when the computer is
turned off. Ensure that the computer is disconnected from its power source
and from all telecommunication links, networks, or modem lines whenever the
chassis cover is removed. Do not operate the computer with the cover
removed. Only qualified service technicians should remove chassis covers if
repair or component replacement is required.
Warning!
Danger of explosion if the battery is incorrectly replaced. Replace only with
the same or equivalent type recommended by the equipment manufacturer.
Discard used batteries according to manufacturer's instructions.