Kenwood DDX5034M - Manual (Page 79)

English 79
9 Adjusts the volume of the present source
based on the difference level of original
volume.
⁄
• If you have increased the volume first, then reduced the
volume using the "Vol. Offset", the sound generated if
you suddenly switch to another source may be extremely
loud.
Equalizer Control
You can set up the equalizer.
1 Display Equalizer Control
Touch in the "Audio
Control Menu" screen (page 78).
2 Display the Equalizer screen
2
3
1
1 Selects an equalizer curve type.
You can select any of the following
equalizer curves.
• "Natural"
• "Rock"
• "Pops"
• "Easy"
• "Top40"
• "Jazz"
• "User"
⁄
• "User" can be selected after tone adjustment is carried
out. See (page 79).
2 Selects items to be adjusted for tone curve
setup.
If turned "OFF", only Level can be setup for
tone curves.
3 Displays the Tone curve setup screen. (page
79)
Tone Setup
You can set a Tone curve.
1 Display the Tone screen
See (page 79).
2 Set the Tone
1
2
3
4
5
6
7
8
9
1 Tone curve becomes flat.
2 Bass adjustment items are displayed.
3 Middle adjustment items are displayed.
4 Treble adjustment items are displayed.
5 Sets the Center frequency.
6 Sets the level.
7 Sets the Q factor. (Only Bass and Middle can
be set)
8 Bass DC Extend settings (Only when Bass is
selected)
If turned "ON", it extends the bass
center frequency to the low register by
approximately 20%.
9 Returns to the "Equalizer" screen.