Samsung SPH-N200 - Manual (Page 24)

Section 2
22 Getting to Know Your Sprint PCS Phone
The Empty Battery Icon
Approximately five minutes before the battery charge level
gets too low to operate the phone, the battery sensor will let
you know by blinking an empty battery icon (
),
sounding an audible alert and displaying a warning
message. If you continue to operate the phone without
charging, the phone will turn off automatically (after a
three to five minute delay). If this happens, your call will
end. If you plug into a charging device, you can continue
your call. Be sure to monitor the battery strength icon and
make sure your battery is adequately charged.
Installing the Battery
Your Sprint PCS Phone comes with a LiIon battery. Follow
these steps to install it:
1. Hold the battery so that the metal contacts on the base
of the battery line up with the metal contacts on the
base of the phone.
2. Place the battery on the back of the phone with the top
of the battery about 1/4 inch to 1/2 inch from the
battery latch.
3. Gently push the battery toward the top of the phone
until it snaps into place.
Removing the Battery
To remove your battery for charging, or for another reason,
follow these easy steps:
Note:
Long backlight settings,
searching for service,
vibrate mode and
MiniBrowser use affect the
battery’s talk and standby
times.
Tip:
Be sure to charge your
phone’s battery and watch
your indicator to ensure
your levels are OK.