Koss KS3101A-2 User Manual
Page 12
E 11
E
(3) Speaker connections
Before Connecting
This DVD Receiver is designed to reproduce optimum sound quality when the supplied speakers are used. If you
wish to connect other speakers to the system instead of the supplied speakers, they should be 6 ohms
impedance with a minimum power handling of 50 watts each.
Maintain correct polarity when connecting speakers (colored wire for positive and black wire for negative).
To prevent damage to circuits, never short-circuit the positive and negative speaker output terminals.
Connection
Connection of all speakers are the same.
Notes
•
Do not remove
excessive amount of
insulation on the wire
cords, to avoid the
stripped portion from
touching each other. The
optimal length for the
stripped part should be
around 1/3 inch (or
1cm).
•
Do not push the
stripped part too far
into the speaker
connectors.
Press the button down & insert the wire, then release the button.
The above connections can be expressed by the below table:
FRONT LEFT FRONT RIGHT
CENTER
SURROUND
RIGHT (REAR)
SURROUND
LEFT (REAR)
SPEAKERS
Speakers
Terminals
Use Wires
Note: always connect colored wire to colored speaker terminal (+).
always connect black wire to black speaker terminal (-).
Unit
Terminals
L+
White
L -
Black
White
Black
R+
Red
R -
Black
Red
Black
C+
Green
C -
Black
Green
Black
SL+
Blue
SL -
Black
Blue
SR+
Grey
SR -
Black
Grey
Black
PASSIVE
SUBWOOFER
+
-
Black
Black
Purple
Purple
Black