Kodak CX4310 User Manual
Page 72
64
Chapter 9
Camera freezes up
when a card is
inserted or
removed.
Camera detects an error
when the card was
inserted or removed.
Turn the camera off, then
back on. Make sure the
camera is turned off before
inserting or removing a
card.
Picture is too light. The flash is not needed. Change to Auto flash
(
).
The subject was too
close when the flash was
used.
Move so there is at least 1.6
ft (0.5 m) between the
camera and the subject.
Lighting condition is too
bright.
Decrease exposure
compensation (
).
Stored pictures are
damaged.
The card was removed
when the ready light was
blinking.
Make sure the ready light is
not blinking, then turn off
the camera before removing
the card.
Pictures remaining
number does not
decrease after
taking a picture.
Picture does not take up
sufficient space to
decrease the picture
remaining number.
The camera is operating
normally. Continue taking
pictures.
Picture orientation
is not accurate.
The camera sensed that
it was rotated or tilted
while the picture was
taken.
Set the Orientation Sensor
(
). Turn off the
Orientation Sensor when
your subject is above or
below you (such as in the
sky or on the floor).
Camera
Problem
Cause
Solution