beautypg.com

Kenwood KDC-5026G User Manual

Page 25

background image

English

|

25

Screwing the Faceplate on the Unit

If you want to fasten the faceplate to the main
unit so that it does not fall off.

1

Refer to the section 'Removing the hard rubber

frame' (page 26) and then remove the hard
rubber frame.

2

Drop open the faceplate by pressing the Release

button.

3

Tighten the screws (ш2.6 Ч 12 mm) (Accessory

5) in the holes shown on the diagram.

Accessory

5

4

Tighten the screws (ш2 Ч 4 mm) (Accessory

6) in

the holes shown on the diagram.

Accessory

6

5

Tighten the screws (ш2 Ч 6 mm) (Accessory

7) in

the holes shown on the diagram.

Accessory

7

• Never insert the screws in any other screw hole than the

one specified. If you screw them in another hole, it will
contact and may cause damage to the mechanical parts
inside the unit.

This manual is related to the following products: