Socket Mobile Series 9 - Manual (Page 20)

STEP 3: Connect CRS to Host Device with Bluetooth
**SocketScan supports a generic Bluetooth COM port and may be able to
connect to Bluetooth stacks on host mobile computers other than those
listed.
1. Turn on the Cordless Ring Scanner. Press the small power button on the
side of the wrist unit for at least 2 seconds, until you hear a beep. The
Bluetooth status LED on the wrist unit should be blinking blue.
2. Turn on the Bluetooth radio of your mobile device. Refer to your
device manual for instructions.
Note: Your Bluetooth software may be different than above.
3. If you did not install Connect!Agent, make sure a COM port is enabled
for outbound Bluetooth serial communication. Refer to the device
manual.
4. Tap Start | Programs | SocketScan.
Disregard the icons for Socket Trigger RFID,
Socket Trigger Scan, and Socket Trigger Select.
5. Tap on the SocketScan icon at the bottom of the screen. In the pop-up
menu, tap Connect CS.
20