Speco Technologies SIPT5 - Manual (Page 93)

2-89
010100XXXX 10 000001XXXX 32 011011XXXX 54
110100XXXX 11 100001XXXX 33 111011XXXX 55
001100XXXX 12 010001XXXX 34 000111XXXX 56
101100XXXX 13 110001XXXX 35 100111XXXX 57
011100XXXX 14 001001XXXX 36 010111XXXX 58
111100XXXX 15 101001XXXX 37 110111XXXX 59
000010XXXX 16 011001XXXX 38 001111XXXX 60
100010XXXX 17 111001XXXX 39 101111XXXX 61
010010XXXX 18 000101XXXX 40 011111XXXX 62
110010XXXX 19 100101XXXX 41 111111XXXX 63
001010XXXX 20 010101XXXX 42
101010XXXX 21 110101XXXX 43
011010XXXX 22 001101XXXX 44
2.4.7 PROTOCOL (SIPSD10X only)
7 th ~8 th dip switches are used for Protocol Setting.
Factory Default: Pelco-D or Pelco-P ( Auto detection)
DIP SW1- 7 DIP SW1- 8
OFF OFF Pelco-D or Pelco-P
2.4.8 BAUD RATE SETTING (SIPSD10X only)
The 9 th Dip Switch is used for BAUD RATE setting.
DIP SW can be changeable to 2400bps, 9600bps.
Factory Default: 9600bps.
DIP SW1 9 th BAUD RATE
OFF 2400
ON 9600