Siemens M SERIES MG-2D - Manual (Page 17)

Multi Address Appearance on OpenStage 00.00.2007 I 17
The Originating line preference parameter determines which line will be used when the user goes
off-hook or starts on-hook dialling.
Remark: When a terminating call exists, the terminating line preference takes priority over originating
line preference.
The following preferences can be configured:
"idle line": An idle line is selected. The selection is based on the Hunt ranking parameter
assigned to each line ( “Line key configuration”). If all available lines are used a PopUp is
shown for further outgoing calls indicating, that no further line is available.
"primary": The designated Primary Line/Main DN is always selected for originating calls. If the
primary line is already used a PopUp is shown for further outgoing calls indicating, that no
further line is available, even if other lines are configured and available. In this case the user
has to select manually the line for the outgoing call.
"last": The line selected for originating calls is the line that has been used for the last call
(originating or terminating). If the last line is already in use a PopUp is shown for further
outgoing calls indicating, that no further line is available even if other lines are configured. In
this case the user has to select manually the line for the outgoing call.
"none": The user manually selects a line by pressing its line key before going off-hook, or by
pressing the speaker key, to originate a call. Manual line selection overrides automatic line
preferences.
The Terminating line preference parameter decides which terminating line, i. e. line with an
incoming call, is selected when the user goes off-hook.
The following preferences can be configured:
"ringing line": The line in the alerting or audible ringing state is automatically selected when
the user goes off-hook. In the case of multiple lines alerting or ringing, the lines are selected
on the one that has been alerting the longest.
"ringing PLP": The line in the alerting or audible ringing state is automatically selected when
the user goes off-hook. However, if the prime line is alerting, it is given priority.
"incoming": The earliest line to start audible ringing is selected, or else the earliest alerting
(ringing suppression ignored) line is selected.
"incoming PLP": The earliest line to start audible ringing is selected, or else the earliest
alerting (ringing suppression ignored) line is selected. However, if the prime line is alerting, it
is given priority.
"none": To answer a call, the user manually selects a line by pressing its line key before going
off-hook, or by pressing the speaker key. Manual line selection overrides automatic line
preferences.
Line action mode determines the consequence for an established connection when the line key is
pressed. If "hold" is selected, the call currently active is set to hold as soon as the line key is activated.
The user has two options: 1) to reconnect to the remote phone by pressing the line key that
corresponds to that call, or 2) to initiate another call from the newly selected line. If "release" is
selected, the previously established call is ended.
If Show Focus is checked, the LED of a line key flutters when the line is in use. If it is not checked, the
line key is lit steady when it is in use.
The Reservation timer sets the period after which the reservation of a line is canceled. A line is
automatically reserved for the keyset whenever the user has selected a line for an outgoing call and
hears a dial tone. If set to 0, the reservation timer is deactivated.
Forward indication activates or deactivates the indication of station forwarding, i. e. the forwarding
function of OpenScape Voice. If Forward indication is activated and station forwarding is active for the
corresponding line, the LED of the line key blinks.