Siemens M SERIES MG-2D - Manual (Page 16)

Multi Address Appearance on OpenStage 00.00.2007 I 16
Administrative Options
The MAA is a subset of the SEN proprietary MLA. Therefore the administrative settings are used in both
scenarios. The explained configuration parameters are reduced to the MAA needed settings. A
deviating usage of the parameter will enable the MLA, which is only supported by the SEN OpenScape
Voice platform.
There are two sets of options
A general set of options affecting all type of configured line keys. These options are used,
when at least one FKP is configured as (primary) line key.
A set of options per line key. These options are specifying the behaviour of the specific line
key and do not have a general purpose. Each line key can have different settings.
General Keyset Options
WBM Configuration:
Admin -> System -> Features -> Keyset operation.
General Keyset Options:
The options can be set via WBM,
WPI und local phone admin.
The following parameters provide general settings which are common for all keyset lines. The Rollover
ring setting will be used when, during an active call, an incoming call arrives on a different line.
"no ring": The incoming call will not initiate a ring.
"alert ring": A 3 seconds burst of the configured ring tone is activated on an incoming call;
"alert beep": A beep is played in the current call instead of a ring tone.
"standard ring": Selects the default ringer.
LED on registration determines whether the line LEDs will be lit for a few seconds if they have been
registered successfully with the SIP server on phone startup.