Siemens M SERIES MG-2D - Manual (Page 15)

Multi Address Appearance on OpenStage 00.00.2007 I 15
User Line Key Configuration
The keyset line configuration can be
done for every line. Each line has an
own tab with the same parameters.
Parameter Meaning
Ring delay (seconds) Number of seconds until the phone will play the ringing tone for an
incoming call.
Allow in overview If checked, the line will be shown in the overview table
Address Administrated address (fixed)
Primary line Line status (fixed)
Ring on/off If checked a ringer tone is played for incoming calls. (fixed)
Selection Order Used for outgoing calls if idle lines are selected automatically
Hot/warm line Not used in this context. (fixed)
Hot/warm
destination Not used in this context. (fixed)
Overview Configuration Menu
The menu can be reached using the Web Based Management (WBM) or the local user menu at the
phone. The location is:
User -> Configuration -> Keyset -> Overview
The overview screen can be
configured by the user.
Parameter Meaning
Use FPK order The phone will order the line entries in the overview table according to the order
of the configured FPKs
Add all lines All lines are added to the overview table
Ordering
icons The icons can be used to order the line entries suitable to the users needs