Sharp FO-2950M - Manual (Page 27)

Setting Up the Multifunction Interface
25
1. Ins
tall
a
tion
Note: There is normally no need to change the parallel port setting in
your computer's setup (BIOS) program. However, if you find that the
Sharp Laser Multifunction fax does not operate well when scanning or
printing, you may need to change the setting. In this case select ECP,
PS2, Bi-directional, or an equivalent parallel port mode.
3
Connect the other end of the cable to
the parallel port on the back of your
computer.
2
Connect one end of the cable to the
port on the Sharp Laser
Multifunction. Snap the clips on each
side of the port onto the cable
connector to secure it.
all-fo2950.book Page 25 Monday, September 25, 2000 8:57 AM