Sony CDP-CX53 - Manual (Page 14)

14
Playing CDs
Changing the programmed order
You can change your program before you start playing.
To
Erase a track or disc
Erase the last track or
disc in the program
Add tracks or discs to the
end of the program
Change the whole
program completely
Erasing the program stored in memory
1
Press PLAY MODE repeatedly until “PROGRAM”
appears in the stop mode. When using the remote,
press PROGRAM.
2
Hold down CLEAR until “Clear” appears in the
display.
You need to
Press CHECK until the track or
disc you want to erase appears in
the display, then press CLEAR
Press CLEAR. Each time you
press the button, the last track or
disc will be cleared.
Follow the programming
procedure
Hold down CLEAR until
“Clear” appears in the display to
erase the whole program, then
create a new program following
the programming procedure
Checking the programmed order
You can check your program before or after you start
playing.
Press CHECK.
Each time you press this button, the display shows the
disc and track number of each step in the programmed
order. (When a whole disc is programmed as one step,
“AL” appears instead of the track number.) After the
last step in the program, the display shows “End” and
returns to the original display.
Creating a program using the remote
CHECK
·
PROGRAM
Number
buttons
ENTER
CLEAR
1 Press PROGRAM.
2
Press DISC.
3 Press the number button of the disc.
4 To program a whole disc, press ENTER and go to
Step 6.
5 Press the >10 button, then the number button of
the track.
6
To program other discs/tracks, do the following:
To program
All tracks of another disc(s)
Other tracks on the same disc
Other tracks on other discs
7 Press · to start Program Play.
To cancel Program Play
Press CONTINUE.
Repeat Steps
2 to 4
5
2, 3 and 5
DISC
>10