Sharp X2 - Manual (Page 36)

24 Operations
3
1
2
Platen guide
Operating the cutter (con’t)
Replacing cutter blade
The procedures to replace the cutter blade are:
Procedures
1. At the printer’s operations panel, press the
Menu button (top button) to enter menu mode.
2. Use the arrow buttons to scroll to Replacing
Blade and press the associated button to
proceed.
3. The operation panel will display: "Move to the
center". Press the associated button to move
the cutter blade to the center.
4. The operation panel will display: "Open
top/front cover". Open the top cover. After
opening the top cover, the panel will again
instruct to open the front cover.
5. Open the top cover and then press the button
associated with NEXT.
6. Manually move the cutter blade to the very
center if not properly centered.
7. The operation panel will display: "Replace
blade and press reset".
8. To remove the cutter, push down the cutter
blade.