Sharp PG-D3550W - Manual (Page 50)

46
5-1 EDID Selection
EDID (Extended Display Identifi cation Data) is
data that enables a computer to make proper
display settings.
When you cannot fi nd the desired resolution
on your computer, switch EDID selection. If
still unsuccessful, reboot the computer.
Selectable
items
Description
Standard Standard setting.
Enhanced When the desired resolution cannot
be found in standard setting.
5-2 Setting the Video System
The video input system mode is factory preset
to “Auto”; however, a clear picture from the
connected audio-visual equipment may not be
received, depending on the Video signal
difference.
In that case, switch the Video signal.
Selectable items
Auto
PAL
SECAM
*NTSC4.43
NTSC3.58
PAL-M
PAL-N
PAL -60
* When reproducing NTSC signals in PAL
video equipment.
The Video signal can only be set in S-VIDEO
or VIDEO mode.
When “Video System” is set to “Auto”, you
may not receive a clear picture due to signal
differences. Should this occur, switch to the
video system of the source signal. •
•
Note
Signal Adjustment (“SIG-ADJ” Menu)
(Continued)
Menu operation n Page 40
6 Setting the Video Setup
Selectable
items
Description
0 IRE Sets the black level to 0 IRE.
7.5 IRE Sets the black level to 7.5 IRE.
This function is available for the following
signals.
With COMPUTER/COMPONENT 1 or 2 input:
- 480
I
With S-VIDEO or VIDEO input:
- NTSC3.58
•
Note
7 Checking the Input Signal
This function allows you to check the current
input signal information.