Siemens CXT70 - Manual (Page 97)

©
Sieme
ns
AG
2003, C:\Sieme
ns\P
rod
ukte
\CX70\output\FUG\C
X70
_FU
G_e
n_
040910_rs_
pk_druck\ULYR_N
etwor
k.fm
Setup 96
VAR Langua
ge: en; V
A
R issue
date: 040728
left page (96) of CX70 Retail fug en, A31008-H7103-A1-1-7619 (10.09.2004, 12:18)
Create/change entry:
or select an existing entry,
then select a new service
provider in the list and
confirm.
Record new service provider (last
entry in the list):
Furth.network
Select, enter the provider data and
save it.
Band selection b
Select either GSM 900, GSM 1800 or
GSM 1900. Make sure that your ser-
vice provider supports the selected
band.
Fast search
When this function is active, net-
work reconnection is speeded up
(standby time is reduced).
User group b
Depending on service provider, you
can create groups with this service.
These can have access to internal
(company) information, for exam-
ple, or special tariffs apply. The
details can be clarified with your
service provider.
Active
Activate/deactivate function. "User
group" must be deactivated for nor-
mal phone use.
Select group
You can select or add groups other
than preferred groups (see below).
Code numbers for the groups are
obtained from your service provider.
All outgoing
In addition to network control for a
user group, it is possible to set
whether outgoing calls outside the
group are permitted. If the function
is deactivated, only calls withinthe
group are permitted.
Pref. group
If activated, calls may only be made
within this standard user group
(depending on the network configu-
ration).
Additional information
If you are outside your home network, your
phone automatically dials another GSM
network.
If the signal strength of the preferred net-
work is inadequate when you switch on the
phone, the phone may register in a different
network. This can change when the tele-
phone is next switched on or if another net-
work is selected manually.