beautypg.com

Charging the battery, Charging time, Operating time – Siemens CXT70 User Manual

Page 11: Charge icon not visible, Display while in service

background image

©

Sieme

ns

AG

2003, C:\Sieme

ns\P

rod

ukte

\CX70\output\FUG\C

X70

_FU

G_e

n_

040910_rs_

pk_druck\ULYR_Startup.f

m

Getting started

10

VAR Langua

ge: en; V

A

R issue

date: 040728

left page (10)

of CX70 Retail fug en, A31008-H7103-A1-1-7619 (14.09.2004, 10:44)

Charging the battery

Charging the battery

The battery is not fully charged when

delivered. Plug charger cable into the

bottom of the phone, plug power

supply unit into a mains power socket

and charge for at least two hours.
As an alternative, the battery can be

charged via the USB port (see

Accessories, p. 133).

Y

Display during charging.

Charging time

An empty battery is fully charged

after about 2 hours. Charging is only

possible within a temperature range

of +5 °C to 45 °C. If the temperature

rises/falls 5 °C above/below this, the

charge symbol flashes a warning.

The mains voltage specified on the

power supply unit must not be

exceeded.

Operating time

The operating time depends upon

the respective conditions of use.

Extreme temperatures considerably

reduce the phone’s standby time.

Avoid placing the phone in the sun

or on a heater.
Call time: 100 to 330 minutes

Stand-by time: 60 to 300 hours

Charge icon not visible

If the battery has been discharged

fully, the charge icon is not immedi-

ately visible when the power supply

is plugged in. It will appear after up

to two hours. In this case the battery

is fully charged after 3 to 4 hours.
Only use the plug-in power supply

included in delivery!

Display while in service

Charge level display during opera-

tion (empty–full):

V

W

X

A beep sounds when the battery is

nearly empty. The charge level of the

battery is only displayed correctly

after an uninterrupted charging/dis-

charging cycle. You should therefore

not remove the battery unnecessarily

and where possible not finish the

charging process prematurely.

Additional information
The power supply unit heats up when used

for long periods. This is normal and not

dangerous.
If the battery is removed for longer than

30 seconds, the clock must be reset.

This manual is related to the following products: