Shindaiwa X7502863700 User Manual

Page 13

Cable adjustor

Locknut

Throttle cable

Throttle lever free play

5-7 mm (0.2-

0.275”)

Fuel filter

Hooked

wire

50 hour maintenance

CAUTION!
Make sure you do not pierce the fuel

line with the end of the hooked wire.

The line is delicate and can be dam-

aged easily.

(more often in dusty or dirty conditions):
Remove and clean the cylinder cover and clean grass and dirt from the

cylinder fins.

Gearcase Lubrication

Remove the gearcase cover, and use solvent and a soft brush to

remove all old grease from the gearcase. To refill, hand-pack the

gearcase with approximately 40–50 grams of high quality lithium-

based grease (50–70% of capacity). DO NOT OVERFILL!

Throttle free play adjustment

If the unit does not return to idle speed

or doesen’t reach full rpm, the throt-

tle trigger free play may need to be

adjusted as follows:

Measure free play at the end of

the throttle trigger. Throttle trigger

free play should be approximately

5-7 mm (0.2-0.275”).
If adjustment is necessary, remove

the air cleaner cover by loosening

the thumbscrew. Loosen the cable

adjuster lock nut and turn the cable

adjustment fitting in or out until throt-

tle lever free play is approximately

5-7 mm (0.2-0.275”).
Replace the air cleaner cover, and

tighten the cover retaining screws

securely.

Remove and Replace Fuel Filter

Use a wire hook to extract the fuel fil-

■

ter from inside the fuel tank. Inspect

the fuel filter element. If it shows

signs of contamination from debris,

replace it with a genuine Shindaiwa

replacement fuel filter element.

Before reinstalling the filter, inspect

■

the fuel line. If you discover damage

or deterioration, the unit should be

removed from service unitl it can be

inspected by a Shindaiwa-trained ser-

vice technician.

Gearcase cover

Hex

screws

BOTTOM VIEW

DO NOTE REMOVE

CONRODS