Southbend SB1023 - Manual (Page 25)

For Machines Mfg. Since 8/09 Model SB1023
-23-
O P E R A T I O N
7. Oil the threads and thread the hub puller
(Figure 25) into the hub until it stops.
Figure 25. Hub puller.
Hub
Puller
Hub
8. While holding the wheel and hub from
sliding off of the spindle, tighten the hub
puller bolt until the wheel and hub assembly
are pulled off the spindle as shown in
Figure 26.
Figure 26. Pulling wheel hub.
Hold
6. Remove the spindle bolt (Figure 24).
Figure 24. Spindle bolt removal.
Spindle bolt
Hub
4. Position a 12mm open end wrench on the
spindle shaft that protrudes from the motor
fan cover (Figure 22).
Figure 22. Spindle shaft.
5. Using the wrenches, turn the spindle bolt
clockwise as shown in Figure 23.
Figure 23. Hub removal.
Hold