Fig w, Fig n fig o – Siemens 5551 User Manual

Page 24

Fig N

Fig O

Fig W

Screw in the new main burner tip, pushing the

burner tip casing in the opposite direction with a

13 mm spanner.

Loosen the holding screw Fig. L1 and set the

regulating bushing of the air flow to the value

indicated in the burner tip table.-Z-

Tighten the locking screw.

7 - Changing the inner flame burner tip.

Using an 8 mm spanner, unscrew the connector

Fig. M3 from the threaded component Fig. M2. To

do this, hold the threaded component firmly in the

Fig. N.

Then, using a 12 mm spanner, unscrew the

threaded component Fig. M2 from the component

Fig. M1, holding the latter firmly in the opposite

Unscrew the burner tip Fig. M4 from component

Fig. M2 and replace it with the appropriate burner

tip as indicated in the burner tip table, and adjust

the regulating bushing of the air flow M5 in line with

the value indicated in the burner tip table. -Y-

* If the appliance is not firmly fixed or the clipping

system is too rigid, it may cause the entire appliance

to lift up. In this case follow this procedure:

1) Loosen the fixing clips of the appliance to

the kitchen unit.

2) Loosen the main gas connection and take

the appliance out of its seating.

3) Apply the disassembly lever 483196 as

shown in Fig. W.

direction with a 12 mm spanner. See Fig. O.

C) Reduced consumption adjustment of the

opposite direction using a 12 mm spanner. See

cooktop burner taps.

1 - Set the taps to the minimum setting.

2 - Remove the control knobs from the taps. Fig. 6.

Fig. M.

IMPORTANT INFORMATION

This manual is related to the following products: