Siemens 5551 - Manual (Page 23)

Fig. 5
5a
5c
5b
X1
X2
X3
B) Changing the tips on the upper large
double flame burner.
following steps must be taken to remove both the
glass panel and frames:
1 - Remove all the burners, caps, diffusers,
2 - Loosen the two screws on the rapid, semi-
3 - Loosen the three screws on the large double
etc. Fig. 5a.
rapid and auxiliary burners. Fig. 5b.
flame burner. Fig. 5c.
The glass panel and the frame are fixed to the
rest of the cooking hob by means of clips. The
4 - Use the disassembly lever 483196 available
from our technical assistance service. To release
the front clips, apply the lever in the area shown in
Never use the lever on glass edges which have
no trim or frame!
Before putting the glass back, check that the
watertight seals are properly adjusted.
5 - To release the rear clips, carefully raise the
entire glass unit along with the frame, as in
figures X1, X2, depending on the hob model.
Fig. X3.
6 - Changing the outer flame burner tip.
Take out the main burner tip turning it to the left
with a 10 mm spanner. At the same time, hold the
burner tip casing in the opposite direction with a
21
13 mm spanner. Fig. K.
Fig. L.
IMPORTANT INFORMATION