Siemens 5551 User Manual
Page 20
A
D
E
C
B
F
Fig. 1a
The seal ensures that the entire work
seepage.
If this item has not been fitted in the factory,
remove the pan supports and the gas burner
covers and diffusers from your cooking hob,
adhesive
appliance
hob,
Depending on the model, the clips and the
may already be fitted; if this is the case, do not
remove them under any circumstance.
and turn it upside down.Now fit the
surface
will be watertight, and prevents water
seal
supplied with the
onto the lower edge
of the cooking
Fig. 2a,remove the clips from
the attached accessories bag and screw them
into the lower points designed for this purpose,
Fig. 2 b.
3 -
watertight seal (lower edge of the cooktop)
Place the cooktop in the middle of the
Once the hob is fitted you should turn the clip
If the oven is not installed under the cooktop,
place a separator of non-flammable material to
prevent access to the lower part of the cooktop.
To install the cooktop over an oven, check the
dimensions given in the installation manual.
A- Minimum 6” (152 mm)
B- Minimum 6” (152 mm)
C- Minimum 30” (762 mm)
D- Minimum 2” (51 mm)
E- Minimum 36” (915 mm)
F- Minimum 18” (458 mm)
Requirements for the cabinet
Appliance installation
IMPORTANT INFORMATION
Maximum depth of cabinets installed above
cooktop: 13" (330 mm.)
Figure. 2a
Figure. 2b
Figure. 2c
19
1
/
4
”
min. 6”
min. 2
13
/
16
”
min. 7
1
/
4
”
Fig. 1b
33
1
/
2
”
1
3
/
4
”
1
1
/
16
”
19
1
/
4
”
33
1
/
2
”
1
1
/
16
”
kitchen unit.
opening where it is to be inserted into the
the reverse manner.
disassembly, unscrew the clip and proceed in
Note: do not stick the hob onto the worktop
and tighten the screw as shown in Fig. 2b. For
with silicone.
18