SMC Networks SMC-EZ109DT - Manual (Page 16)

A
BOUT THE
EZ S
WITCH
10/100
4
Rear Panel
The AC power receptacle is located on the rear panel of the
switch.
Gigabit Port
LINK/
ACT Off The port has not established any network
connection.
On The port has established a valid network
connection.
Flashing The port has established a valid network
connection and traffic is passing through the
port.
10/100M On The port has established a valid network
connection and communications have been
set to 100 Mbps.
1000M On The port has established a valid network
connection and communications have been
set to 1000 Mbps.
FDX/
COL On The port is in full-duplex mode.
Off The port is in half-duplex mode.
Flashing Packet collision is occurring in half-duplex
mode.
Port and System Status LEDs
LED Condition Status
100-240V~ 50-60Hz 0.3A