StarTech.com StarView SV1632DS - Manual (Page 19)

17
g Manual Scan enables you to manually switch back and forth
between power-on computers.
left Ctrl + left Ctrl + F2
Press
áor âto select the previous or the next computer in sequence.
And, press any other key to abort the Manual Scan.
Note: For OSD models, Scan Type determines whether eye mark is
necessary during Manual Scan.
g To adjust Scan Rate which sets the duration before switching to
the next computer in Auto Scan:
left Ctrl + left Ctrl + F3
The StarView sends one to four beeps indicating scan interval of 3, 8,
15 and 30 seconds respectively.
g To adjust keyboard typematic rate (characters/sec), this setting
over-rides that of BIOS and any operating system:
left Ctrl + left Ctrl + F4
The StarView generates 1 to 4 beeps corresponding to 10, 15, 20
and 30 characters/sec respectively.
g Audio Stick
An optional multimedia module can be LINKed to the back of each
StarView for selecting microphone and stereo speaker signals.
There are two options for Audio Stick: ON and Off. When set to 'On',
audio selection follows computer selection. When set to 'Off', audio
selection stops following computer selection. It is useful if you want
to listen to a particular computer's audio signal while operating
other computers.
left Ctrl + left Ctrl + F5
The StarView generates 1 or 2 beeps corresponding to On and
Off respectively.
Cascade Configuration
Connection
Before connecting a device (a computer or a Slave) to the Master
under power, you must turn off the device. The Master must have