Sirius Satellite Radio SIRIUS STILETTO 10 - Manual (Page 18)

Sanyo CRSR-10 User Guide Sanyo CRSR-10 User Guide
Specifications
Audio Output ............................................................................................. 776 mV RMS or 1 v peak to peak)
Total Harmonic Distortion (THD) .......................................................................................................... <0.5%
Signal-to-noise (S/N) ........................................................................................................Greater than 83dB
Fuse Requirement .................................................................................................................... 3A Slow Blow
Power Supply ...............................................................................................7.6V-24V, Negative Ground, DC
Current Requirement............................................................................................................................................1A
Operating Temperature..........................................................................................................................-20 - +70C
CRSR-10 Dimensions ....................................................................... 101mm(W) x 101mm(H) x 32mm(D)
........................................................................................................................... (3.97” W x 3.97” H x 1.26” D)
CRSR-10 Weight ..................................................................................................................................... 240g
35
Troubleshooting
FAULT PROBABLE CAUSE
No Sound
No signal on CRSR-10
display
Audio static or loss of
clarity
“Antenna
Not Detected”
message
CRSR-10 does not turn on
1. Audio Cables not connected
2. Incorrect FM modulator frequency
3. FM transmitter option not turned on
Check for obstacles over or around
antenna or move antenna placement
Vehicle antenna not connected to radio
FM modulator frequency contains static
Antenna or cable is faulty
Satellite antenna not connected
Blown Fuse, power cable not properly
connected
1. Check cables at CRSR-10 and radio
2. Select another FM frequency
3. Turn on FM transmitter in CRSR-10
menu
Change location to eliminate nearby
obstacles (bridge, trees, etc.)
Check vehicle antenna cable
1. Switch to another FM frequency
2. Move CRSR-10 closer to car FM
antenna
3. Use FM switching box
Contact system installer or vendor
Check satellite connection to CRSR-10
Check fuse, check power cable
34
Note: Features and Specifications subject to change without notice.
REMEDY