Snapper Clean Sweep Twin Catcher - Manual (Page 13)

Normal Removal
11
A. Hitch Support Assembly G. Middle & Upper Tube
B. Cover
H. Lower Chute
C. Pin I. Pin
D. Hair Pins J. Strap Middle
E. Bag K. Ridge
F. Grass Bag Hanger L. Ridge Cutout
E
K
D
B
Figure 14. Normal Installation & Removal
C
I
H
L
A
Collector Removal
1. Unhook strap (J, Figure 14) from pin (I). Remove
middle and upper tube (G) from cover (B).
2. Lift up cover (B) remove and empty bags (E).
3. Remove hair pins (D) and pins (C) and remove cover
(B).
Note: To prevent loss of parts reinstall pins (C) and hair
pins (D) in support assembly hinge pivots (E, Figure
10).
WARNING
OPERATION WITHOUT BAGGER
For operation without bagger, the mower
deflector MUST be properly installed in the down
position and retained by the spring latch.
J
4. Remove hitch support assembly (A, Figure 14).
5. Lift discharge deflector up (E, Figure 13).
6. Remove wing nut (D) from carriage bolt (F).
7. Remove the knob (B) from carriage bolt (C).
8. Remove the lower chute (A) from carriage bolt (F).
9. Remove lower chute (A) from carriage bolt (C).
G
F
D
C