Snapper Clean Sweep Twin Catcher - Manual (Page 12)

Normal Removal &
Installation
10
Normal Removal & Installation
Collector Installation
Note: See previous pages for more detailed installation
and operation instructions if necessary.
1. Lift discharge deflector up (E, Figure 13).
2. Place the front hole of the lower chute (A) onto
carriage bolt (C) as shown. Slide front edge of lower
chute (A) under hinge bracket (G).
3. Place the rear hole of the lower chute (A) onto
carriage bolt (F) as shown.
4. Secure knob (B) onto carriage bolt (C) as shown.
5. Secure wing nut (D) onto carriage bolt (F) as shown.
6. Install the upright support (B, Figure 8) to hitch (A)
and secure with 3/8-16 x 1 capscrews (C) and
locknuts (D) as shown.
7. Install the bag and cover support (B, Figure 9) to
upright support (A) using reinforcement plate (C) and
3/8-16 x 1 capscrews (D) and 3/8-16locknuts (E) as
shown.
8. Attach cover assembly (B, Figure 10) to bag support
bracket (A) using hinge pivots (E). Secure cover
using cover hinge pins (C) and hair pins (D) as
shown.
9. Raise the cover (A, Figure 9), and attach collector
bags (B) using grass bag hanger (C) to bag hanger
post (D).
10. Slide the upper and middle tube (J, Figure 14)
aligning ridge (L) with cutout (M) as shown.
9. Slide middle and upper tube (J) over lower chute (H).
Pull strap (K) and place hole completely over pin (I).
C
E
D
A
B
Figure 13. Install Lower Discharge Chute
A. Lower Chute
B. Knob, 5/16-18
C. Front Carriage Bolt, 5/16-18 x 3/4
D. Wing Nut, 5/16
E. Discharge Deflector
F. Rear Carriage Bolt, 5/16-18 x 3/4
G. Hinge Bracket
F
G