Southbend METAL-CUTTING BANDSAW SB1019 - Manual (Page 19)

For Machines Mfg. Since 8/09 Model SB1019
-17-
P R E P A R A T I O N
3. Insert the work stop rod approximately 3 ⁄
4
"
into the vise base.
4. Tighten the hex bolt shown in Figure 12.
5. Slide the work stop onto the work stop rod,
position it as necessary, then tighten the leaf
screw.
Hex Bolt
Leaf Screw
Figure 12. Installing stop rod.
Power Connection
Electrocution or fire
may occur if machine is
ungrounded, incorrectly
connected to power, or
connected to an undersized
circuit. Use a qualified
electrician to ensure a safe
power connection.
Once your machine is set up and assembled as
previously described in this manual, it is ready to
be connected to the power source.
— If you plan to use the machine at 110V,
simply plug it into a receptacle on a 110V
circuit that meets the requirements listed on
Page 10.
— If you plan to use the machine at 220V, you
will have to convert the machine for 220V.
Refer to Electrical, beginning on Page 41.