Spectra Logic T380 - Manual (Page 10)

Replace or Install a Drive Preparing the Library
April 2013 Drive Installation or Replacement—Spectra T200, T380, T680, T950, and T-Finity Library
10
3. Click Replace for the drive that you want to replace.
A Feedback Required screen prompts you to confirm that you want to
replace the drive.
4. Determine the physical location of the failed drive, either by looking for
the drive sled status light that blinks amber or by using the drive’s
component identifier displayed on the Drives screen.
5. Click OK.
Another Feedback Required screen indicates that the requested drive
has been successfully shut down.
6. Proceed to Accessing the Drives on page 12 .
Important
Do not click Remove . This option permanently removes the drive from the
partition. When the replacement drive is installed, it will not be assigned to the
partition from which the malfunctioning drive was removed.
If you click Remove and the selected drive is the only drive in the partition, the
partition will be deleted.
Figure 2 The drive sled (Fibre Channel drive sled shown).
Status LED
Important
Do not respond to the prompt in the Feedback Required screen or perform any
other operations from the user interface (either locally or remotely) until you
complete the replacement procedure. Responding before you replace the drive will
power on and configure the drive you just powered down.