Other functions, Off & go function, Effective tools for your presentation – Sony VPL-CS20 User Manual
Page 18: Off & go function effective tools for your, Presentation
18
Other Functions
Other Functions
If you are leaving the conference room
immediately, turn the projector off, and then,
after the powered tilt adjuster is retracted
into the projector, you can unplug the AC
power cord. After the AC power cord is
unplugged, the fan runs for a certain time
automatically.
• When unplugging the AC power cord, ensure
that the powered tilt adjuster has been
retracted into the projector. Moving the
projector with the powered tilt adjuster
extended may damage the adjuster.
• Turn off the projector according to the
procedure explained in ““Turning Off the
Power” on page 14,” then cool it down before
storing the projector in the carrying case.
• However, if the unit has been on for less than
15 minutes, the fan might not begin to turn as
a result of inadequate charging. In that case,
follow the procedure for turning off the
power as described in “Turning Off the
Power” on page 14.
To enlarge the image (Digital Zoom
function)
You can select a section of the image to
enlarge. This function works when a signal
from a computer is input.
This function does not work when a video
signal is input.
1
Project a normal image, and press the
D ZOOM + key on the Remote
Commander.
The digital zoom icon appears in the
center of the image.
2
Move the icon to the point on the
image you want to enlarge. Use the
arrow key (v/V/b/B) to move the
icon.
3
Press the D ZOOM + key again.
The portion of the image where the icon
is located is enlarged. The enlargement
ratio is displayed on the screen for a few
seconds.
By pressing the + key repeatedly, the
image size (ratio of enlargement: max. 4
times) increases.
Off & Go Function
Notes
Effective Tools for Your
Presentation
Digital zoom icon