Sony DRBT10CX - Manual (Page 9)

9
US
DR-BT10CX_U2 [US,ES] 2-698-598-41(1)
Pairing
Continued
What is pairing?
BLUETOOTH devices need to be
“paired” with each other
beforehand.
Once BLUETOOTH devices are
paired, there is no need for pairing
again, except in the following cases:
• When pairing information is
deleted after repair, etc.
• When this unit is paired with 9 or
more devices.
This unit can be paired with 8
BLUETOOTH devices; if a new
device is paired after 8 devices
have been paired, the device
whose latest connection time is
the oldest among the 8 paired
devices is replaced by the new
one.
• When recognition of the unit by
the device to be connected is
deleted.
• When this unit is initialized.
All pairing information is deleted.
Procedures of pairing
1 Place the connecting
device within 1 m (3 ft)
of this unit.
2 Press and hold the
POWER button for 7
seconds or more to
standby for pairing
while the unit is turned
off.
Notes
• After about 3 seconds, power is
turned on and the indicator
(blue) and indicator (red) flash
together twice. Keep the button
pressed without releasing until
both indicators start flashing
together, then release the button.
This unit enters into pairing
mode.
• If pairing is not established
within about 5 minutes, pairing
mode will be canceled and this
unit will turn off. In this case,
start over from step 1.