Source Technologies 1352 MICR 40 User Manual

Page 36

Secure MICR Printer User’s Guide

Source Technologies

July 2003

Page 32

The commands in Figure 7.1 in order of appearance:

&%STFPASSWORD$

Password Command.

&%SMCP0001$

MICR Definition Command with the count set to one.

&%STP10001$

Unlock Flash Resource number 10001.

&%STP20000$

Unlock Flash Resource number 20000.

&%1B26...3358$

PCL sequence in hex which sets the page format and
enables macro number 10001.

&%1B$(s1p16v0s3b4148T

PCL sequence which changes the font to Univers 16 point.
After the check serial number prints (1000), the printer is
returned to its default font with the following command.

&%1B$(3@

PCL command to return to default font.

&%SMF$2014.44~

Print Secure font command. Note: The tilde ~ is the
command terminator.

&%1B$(s0p12h1s0b4099T

PCL command to change the font to Courier 12 pitch Italic.
Print PCL Fonts from the Front Panel menu for a list of fonts
with their call commands.

&%1B$(3@

PCL command to return to the default font.

&%1B$(20000X!

PCL command to print font number 20000. In this example
font 20000 is a signature previously loaded into flash memory.
Here we call it and print it with an exclamation point (!).

&%1B$(3@

PCL command to return to the default font.

&%1B$&f0S

PCL command to Push (store) the current cursor position.

&%1B$*p296x3184Y

PCL command to move the cursor to 296X , 3184Y. At 300
units of measure, this is .97 inches across and 10.61 inches
down. We are precisely positioning the MICR line.

&%SMD....$

Print E-13B MICR Command. Prints the MICR line. Note
the MICR font character mapping in Appendix A.

&%1B$&f1S

PCL command to Pop (return) the cursor to the pushed
position.

Section 7: IBM Host Programming Features and Examples