Siemens WFXD5202UC - Manual (Page 21)

21
i You can add or reduce laundry as
long as the
start/pause indicator
light flashes (red).
q
Press the start/pause button.
The start/pause indicator light
flashes.
q Open the door.
q Add/remove laundry.
q Close the door.
q Press the start/pause button.
The program continues.
The indicator light is lit (red).
i When the start/pause indicator
light is lit (red), the program can be
interrupted, however the door may
remain locked for safety reasons
(water level, temperature or speed
too high).
i If the spin speed is too high, the
start/pause indicator light is lit
(red). Laundry can be added in
Pause" mode when the drum is at
a standstill.
Canceling an active
program
If you would like to terminate a program
and remove the laundry:
i If a program is interrupted at a high
temperature, leave the laundry to
cool down until the glass is cool to
touch.
i Press the start/pause button
q Turn the program selector to off.
q Open the door.
q Unload the laundry.
i If a program is interrupted at a high
temperature, the door may remain
locked until the appliance has
cooled down.
i If the program is terminated by
switching off the appliance, the
door may remain locked.
After Washing
The start/pause indicator light goes
out.
0:00 appears in the display.
q Open the door.
q Turn the program selector to off.
q
Close the taps.
q Remove the laundry.
i After washing, leave the loading
door ajar to allow the inside of
the washing machine to dry.
Cleaning and
Care
Cleaning the washer
d WARNING d
TO AVOID RISK OF ELECTRIC
SHOCK!
Always disconnect the appliance
from the power outlet before
cleaning.
Never clean the washing machine
with a pressure washer.
d WARNING d
TO AVOID RISK OF EXPLOSION!
Never use flammable solvents to
clean the appliance.
d CAUTION
Occasionally check for any foreign
objects (e. g. coins, paper clips)
between the drum and rubber seal
- To avoid risk of rust!
Cleaning the appliance housing
and control panel
As required:
q
Use hot soapy water or a mild,
nonĆabrasive cleaning agent.
q
Rub dry with a soft towel.
Cleaning the drum
If rust spots have formed due to
leftĆover debris (e.g. coins, paper clips,
nails):
q
Use a chlorineĆfree cleaning agent.
Follow the manufacturer's
instructions. Never use steel wool.
Cleaning the detergent dispenser
If residual detergents or additives have
accumulated
or if softener/bleach are not fully rinsed
out:
q Open the flap of the detergent
dispenser.
q
Pull out the softener/bleach
compartment in a vertical direction
and remove.
q Clean the detergent dispenser
under running water. The
detergent dispenser can be
disassembled into two parts.